Directions for changing IP address to Automatic 5/20/2008

Win 2000
Start
Settings
Control Panel
Network and Dial-up Connections
Local Area Connection
Properties
Internet Protocol (TCP/IP)
Properties
Just click “Obtain an IP address automatically”
Then click “Obtain DNS server address automatically”
OK
OK

Win XP
Start
Control Panel
Network Connections
Local Area Connection
Properties
Internet Protocol (TCP/IP)
Properties
Just click “Obtain an IP address automatically”
Then click “Obtain DNS server address automatically”
OK
OK

Win VISTA
Start
Control Panel
Network and Internet
View network status and tasks
Manage network connections
Local Area Connection
Properties
Internet Protocol Version 4 (TCP/IPv4)
Properties
Just click “Obtain an IP address automatically”
Then click “Obtain DNS server address automatically”
OK
OK



Win 98
Start
Settings
Control Panel
Network
TCP/IP “Name of your network or ethernet card”
Properties
Under “IP Address” tab
Just click “Obtain an IP address automatically”
Under “DNS Configuration” Tab
Then click “Enable DNS”
OK
OK

Linksys Router
Connected to the Internet?
Open Internet Explorer
Type webpage, “192.168.1.1” into top address bar
Leave User Name blank
Type “admin” into password (Unless customer has changed it)
OK
Set “Internet Connection Type” to “Automatic Configuration – DHCP”
Save Changes
OK
If customer cannot remember their password or IP address for router,
Hold down on Reset button on back of router (use a pen or something similar) for 15-20 seconds
Then be sure to visit our website at www.irtc.net for router setup instructions under the Notice of  IP Address Change link if they are concerned about re-securing the unit (if it was even secured before)
It is already setup for Automatic IP address after Reset